Hertz Mille Pro 6.5" 2-way Component Speaker - Pair (MPK 165P.3 PRO)

Mille Pro 6.5" 2-way Component Speaker - Pair

The MPK 165P.3 PRO (Order Code MPK165P3) car audio speakers system energy in the mid-low range ensures a unique listening experience, creating the ideal set up alongside a powerful subwoofer section. The MP 165P.3 woofer electroacoustic parameters have been forged to give it the pure and solid sound of an authentic mid-bass, designed for high dynamic systems. The MPK 165P.3 timbre balance is entrusted to the MPCX 2P.3 crossover featuring a copper inductor with a 1 mm diameter wire to filter the MP 165P.3, which, with its nominal 3 Ohm requires high impulse currents. The tweeter MP 25.3 12dB/Octave crossover is built with extremely high quality 160V bi-metallized polyester film capacitor and an air coil inductor. The tweeter (MP 25.3) level control (0/+2.5dB) provides the ability to adapt the system response to the listener preferences and considering the components installation position.

• 3 Ohm nominal impedance to exploit all the amplifier’s power.
• 14mm height pure copper voice coil wound on a Polyamide former, for exceptional power handling.
• 95mm diameter magnet to maximize the control over the whole excursion.
• Exponential V-cone profile pressed-pulp cone with cotton fibers, combining stiffness and lightweight for a wide frequency response. Cone profile geometrically optimized for utmost linearity and dispersion in the mid frequency range.
• Boundary Free rubber surround, for improved efficiency and wider mid-bass frequency.
• Low mounting depth, acoustically transparent aluminium alloy basket with elegant diamond cutting and featuring the aluminium Hertz logo.
• Full protection metal mesh grill featuring the aluminium Hertz logo and attractive look mineral powder coated inner grill are included for several install combinations.
• Rear chamber filled with selected damping material and sized for lower Fs, to ensure a well damped high pass frequency roll-off, allowing low cut-off frequency crossover point.
• Center Tuning Duct geometry, for lower resonance frequency and reduced harmonic distortion.
• 1mm pure copper wire low series resistance inductors, for low dissipation losses on the woofer section where high transient currents are demanded.
• Small footprint design for easy installation, with top vent grille for efficient heat dissipation.